Adjustable Roller Pipe Jack Welding Stand - BJS106
| Model | Variations |
|---|---|
| 108BJS | “Shortie” Adjustable Roller Stand With Rubber Rollers |
| 109BJS | Adjustable Roller Stand With Rubber Rollers |
| 114BJS/WSS | Adjustable Roller Stand With Stainless Steel Rollers |
| 115BJS | Adjustable Roller Stand W/Adjustable Height |
- Roller Adjustment From Either End Of Carriage With 1 ¼ Hex Nuts
- Rollers 5/8 x 4” Diameter Cast Iron Lathe Turned For Concentricity
- Working Height 30 ¾” at Center Line of Rollers
- Roller Holders Are Made Of Cast Steel
- Adjusting Screw 3/4″ – 6 Pitch Full Acme Thread
- Adjusting Screw Mounted in Oil Lite Bronze Bushings
- Cariage Housing 2” x 3” 11 Gage Tubing
- Leg Pattern 23” x 26” For Working Stability
- Legs Are Of “A” Frame Design
- Center Braces From Middle of Carriage To Lower Leg Brace For Even Distribution Of Load
- All Legs Have 2” Diameter Foot Surface
- Adjustment Of Rollers Will Accept 1/2″ – 48” Diameter Work Piece
- Roller Holders Have Drain Passages To Prevent Trapped Water If Used Outdoors
- Carriage Housing Has Drain Holes to Allow Water To Drain Through Legs
- Legs & Braces 1” Square Tube 16 Gage
- Rollers Are Powder Coated With High Visibility Safety Yellow
- All Stands Are Labeled With Working Capacity Of At Least 2 to 1 Safety Factor
- Certified Testing By Independent Source
- Working Load Capacity 6,000 LBS
- Complete Stand Weighs 32 LBS.
- Stand has Powder Coat Finish