Roller Adjustment From Either End Of Carriage With 1 ¼ Hex Nuts

Rollers 5/8 x 4” Diameter Cast Iron Lathe Turned For Concentricity

Working Height 30 ¾” at Center Line of Rollers

Roller Holders Are Made Of Cast Steel

Adjusting Screw 3/4" – 6 Pitch Full Acme Thread

Adjusting Screw Mounted in Oil Lite Bronze Bushings

Carriage Housing 2” x 3” 11 Gage Tubing

Leg Pattern 23” x 26” For Working Stability

Legs Are Of “A” Frame Design

Center Braces From Middle of Carriage To Lower Leg Brace For Even Distribution Of Load

All Legs Have 2” Diameter Foot Surface

Adjustment Of Rollers Will Accept 1/2" - 48” Diameter Work Piece

Roller Holders Have Drain Passages To Prevent Trapped Water If Used Outdoors

Carriage Housing Has Drain Holes to Allow Water To Drain Through Legs

Legs & Braces 1” Square Tube 16 Gage

Rollers Are Powder Coated With High Visibility Safety Yellow

All Stands Are Labeled With Working Capacity Of At Least 2 to 1 Safety Factor

Certified Testing By Independent Source

Working Load Capacity 6,000 LBS

Complete Stand Weighs 32 LBS.

Stand has Powder Coat Finish